Tuesday activities

Tonight was good at the space,

  • Heated discussion about internet,
  • some new people turn up, Ben, Russel and his son Cake,
  • and of course some hacking.

This is a spare extruder, the control board from the Huxley, and an old power supply bolted to a piece of MDF. The nozzle was drilled out so it could re-extrude 3mm filament for use with the Solidoodle/Printerbot. By changing the speed of extrusion and the height of the output plastic, the final diameter could be smoothly kept around the target 1.75mm.

There where a few small coils produced and left above the printing desk. The plastic is PLA, and free for anyone to use.

2 Likes